LIMITATIONS OF MAGNETIC PARTICLE INSPECTION

  • Magnetic Particle Inspection (MPI) (MT)

    LIMITATIONS OF MAGNETIC PARTICLE INSPECTION

    Posted by sofia on 14/10/2021 at 11:48 am

    • The specimen must be ferromagnetic (e.g. steel, cast iron)

    • Paint thicker than about 0.005″ must be removed before inspection

    • Post cleaning and post demagnetization is often necessary

    • Maximum depth sensitivity is typically quoted as 0.100″ (deeper under perfect conditions)

    • Alignment between magnetic flux and defect is important

    sofia replied 3 years, 1 month ago 1 Member · 0 Replies
  • 0 Replies

    Sorry, there were no replies found.

    Log in to reply.

    Start of Discussion
    0 of 0 replies June 2018
    Now

    Report

    Block Member?

    Please confirm you want to block this member.

    You will no longer be able to:

    • See blocked member's posts
    • Mention this member in posts
    • Invite this member to groups
    • Message this member
    • Add this member as a connection

    Please note: This action will also remove this member from your connections and send a report to the site admin. Please allow a few minutes for this process to complete.

    Report

    You have already reported this .