Diamond Wrap thickness testing and NDT

  • Coating Inspection

    Diamond Wrap thickness testing and NDT

    Posted by holld on 20/01/2022 at 10:08 am

    What is the best method to perform thickness inspection on diamond wrap? We have a client that has requested thickness testing on a diamond wrap placed on piping with operating temperature of 120 degrees C and diamond wrap thickness = 1.5mm or less. One of the options is use of small diameter, low frequency transducer (like aircraft composite testing) but I am not sure if signal would penetrate thru this type of coating and dead zone could also be present in inspection zone due to small thickness of 1.5mm. Any suggestions or if anybody has had experience with this type of inspection?

    diamond wrap
    holld replied 2 years, 10 months ago 1 Member · 0 Replies
  • 0 Replies

    Sorry, there were no replies found.

    Log in to reply.

    Start of Discussion
    0 of 0 replies June 2018
    Now

    Report

    Block Member?

    Please confirm you want to block this member.

    You will no longer be able to:

    • See blocked member's posts
    • Mention this member in posts
    • Invite this member to groups
    • Message this member
    • Add this member as a connection

    Please note: This action will also remove this member from your connections and send a report to the site admin. Please allow a few minutes for this process to complete.

    Report

    You have already reported this .