Tolerance for PMI inspection

  • Positive Material Identification (PMI)

    Tolerance for PMI inspection

    Posted by harry on 27/11/2021 at 6:51 pm

    Hi,

    According to the PMI Procedure i am referring, The composition observed in the PMI machine shall be acceptable within +/-10% of specified range of the element.

    Can any one please provide me any code reference of the +/- 10% tolerance. From where it came?

    anthony-wohali replied 2 years, 12 months ago 2 Members · 1 Reply
  • 1 Reply
  • Positive Material Identification (PMI)

    anthony-wohali

    Member
    28/11/2021 at 3:30 pm

    Hi,
    You can refer to ASME SEC I – Non mandatory appendix-B.
    Clause B-8 of this appendix specifies this acceptance

Log in to reply.

Start of Discussion
0 of 0 replies June 2018
Now

Report

Block Member?

Please confirm you want to block this member.

You will no longer be able to:

  • See blocked member's posts
  • Mention this member in posts
  • Invite this member to groups
  • Message this member
  • Add this member as a connection

Please note: This action will also remove this member from your connections and send a report to the site admin. Please allow a few minutes for this process to complete.

Report

You have already reported this .