Visual Inspection After Welding

  • Visual Welding Inspection

    Visual Inspection After Welding

    Posted by sofia on 14/10/2021 at 1:12 pm

    Inspection After Welding
    • Check weld against code and standards
    • Check size with gauges and prints
    • Check finish and contour
    • Check for cracks against standards
    • Look for overlap
    • Check undercut
    • Determine if spatter is at acceptable levels

    sofia replied 3 years, 2 months ago 1 Member · 0 Replies
  • 0 Replies

    Sorry, there were no replies found.

    Log in to reply.

    Start of Discussion
    0 of 0 replies June 2018
    Now

    Report

    Block Member?

    Please confirm you want to block this member.

    You will no longer be able to:

    • See blocked member's posts
    • Mention this member in posts
    • Invite this member to groups
    • Message this member
    • Add this member as a connection

    Please note: This action will also remove this member from your connections and send a report to the site admin. Please allow a few minutes for this process to complete.

    Report

    You have already reported this .