UT Transfer Correction

  • Welding

    UT Transfer Correction

    Posted by arsal on 15/10/2021 at 1:11 am

    Hi listen,

    I have a weld of 25.4mm to inspect according to DNVOS-F101.
    Unfortunately, we do not have the appropriate DAC block due to material unavailability.
    Our proposal is to use 18.71mm block and perform transfer correction (V-formation, and then in W-formation).

    Does this methodology is acceptable?

    Thanks for your feedback & advise!

    arsal replied 3 years, 6 months ago 1 Member · 0 Replies
  • 0 Replies

Sorry, there were no replies found.

Log in to reply.

Start of Discussion
0 of 0 replies June 2018
Now

Report

Block Member?

Please confirm you want to block this member.

You will no longer be able to:

  • See blocked member's posts
  • Mention this member in posts
  • Invite this member to groups
  • Message this member
  • Add this member as a connection

Please note: This action will also remove this member from your connections and send a report to the site admin. Please allow a few minutes for this process to complete.

Report

You have already reported this .
Powered by  GDPR Cookie Compliance
Privacy Overview

This website uses cookies so that we can provide you with the best user experience possible. Cookie information is stored in your browser and performs functions such as recognising you when you return to our website and helping our team to understand which sections of the website you find most interesting and useful.