PAUT for steep bevels

  • Phased Array Ultrasonics (PAUT)

    PAUT for steep bevels

    Posted by arsal on 15/10/2021 at 1:04 am

    Hi everybody,

    I am working to find a solution for very steep (~8°) and thick (60-120mm) weld bevels and TOFD is out of question as the seams are only accessible from one side. It seems like it’s pretty much impossible to catch any reflection from a lack of fusion in the HAZ but maybe there is a solution I am not yet aware of. Using DLA probes gives a bigger variety of angles to work with but doesn’t solve all the problems.

    Any suggestions? Thanks in advance.

    arsal replied 2 years, 6 months ago 1 Member · 0 Replies
  • 0 Replies

    Sorry, there were no replies found.

    Log in to reply.

    Start of Discussion
    0 of 0 replies June 2018
    Now

    Report

    Block Member?

    Please confirm you want to block this member.

    You will no longer be able to:

    • See blocked member's posts
    • Mention this member in posts
    • Invite this member to groups
    • Message this member
    • Add this member as a connection

    Please note: This action will also remove this member from your connections and send a report to the site admin. Please allow a few minutes for this process to complete.

    Report

    You have already reported this .