Bilfinger UK is looking for a Category 2 plant inspector to work full time at the DSM Dalry site in North Ayrshire. The inspector examines pressure systems and equipment under UKAS RG2, PSSR and COMAH requirements, reviews workpacks, directs plant and NDT inspectors and performs NDT when needed. Incorporated Engineer status with ASME Plant Inspector Level 2 or API 510 and 570 is required, and PCN Level 2 across UT, ET, DPI, MPI and radiography is desirable.

Methods: UT, ET, PT, MT, RT · Level: PCN Level 2 (desirable) · Sector: Process plant inspection

What the job involves

Examine pressure systems and equipment within UKAS RG2, PSSR and COMAH requirements
Write inspection reports that reference NDT results and review finished workpacks
Contribute to near-term and long-range inspection planning and to risk-based inspection schemes, including non-intrusive options
Carry out NDT in support of engineering inspection and look after on-site inspection kit
Direct the work of plant and NDT inspectors to site safety and quality standards, raising permits as needed
Monitor temporary repairs monthly and issue daily progress reports

What you need

Incorporated Engineer with an HNC or NVQ Level 4 in engineering
ASME Plant Inspector Level 2, or API 570 and API 510
PCN Level 2 in UT, ET, DPI, MPI and radiography desirable
Five or more years in a relevant engineering discipline, with at least one year in in-service pressure system inspection
A suitable Category 3 inspector may be offered training up to Category 2

Pay and conditions

Permanent, full-time role of 37 hours per week
Based on site at DSM Dalry

How to apply

Apply directly with Bilfinger UK Limited: the Apply for this job button opens this vacancy on the Bilfinger UK Limited careers site. NDT Inspect found it on the employer’s careers page and checked that it was open on 14 September 2026. It is listed here until 14 December 2026.