ST Engineering's Commercial Aerospace business is hiring an NDT technician based at Changi North Way, Singapore, to work alongside its NDT engineers. The technician calibrates equipment, carries out non-destructive tests and decides whether indications are acceptable under approved procedures. NAS410/EN4179 Level 2 and prior RT, PT, ET, MT, UT or IRT work count in a candidate's favour; the minimum qualification is a Higher NITEC or engineering diploma.

Methods: RT, PT, ET, MT, UT, IRT · Level: NAS 410 / EN 4179 Level 2 (advantage) · Sector: Commercial aerospace MRO

What the job involves

Prepare equipment and run system checks for the NDT method in use
Apply the codes, standards and contract documents relevant to each method
Interpret indications, accept or reject parts and document the outcome
Work closely with the NDT Engineer as part of the team
Follow safety rules, wear the required PPE and take direction from the NDT Level 3

What you need

Higher NITEC or Diploma in Engineering as a minimum
NAS410/EN4179 NDT Level 2 is an advantage
Prior RT, PT, ET, MT, UT or IRT work is an advantage
Must pass a vision acuity test (corrective lenses allowed) and a colour vision check
Able to work across four sites: Changi North, Paya Lebar, Seletar and Changi Creek
No fear of confined spaces or heights

Pay and conditions

Rotating shifts with occasional night shifts
Overtime when requested

How to apply

Apply directly with ST Engineering: the Apply for this job button opens this vacancy on the ST Engineering careers site. NDT Inspect found it on the employer’s careers page and checked that it was open on 14 September 2026. It is listed here until 14 December 2026.