AAR is hiring a Level II NDT inspector at its Miami aircraft services site in Florida. The inspector sets up and runs non-destructive tests on aircraft and components, decides whether parts are accepted or rejected and records the results the way the customer requires. Three to four years of aircraft NDT and a Level II certificate in at least one method are needed; an FAA A&P licence is preferred.
Level: Level II · Sector: Aircraft maintenance and repair
What the job involves
- Set up and standardise the test equipment, process the parts and run system performance checks to the process standard
- Read indications and judge them against the applicable standards to accept or reject the part
- Write up every inspection on the customer's paperwork
- Prepare parts for inspection and clean them afterwards as the method needs
- Draft work instructions from approved general procedures where the written practice allows, for sign-off by a Level III
- Guide and supervise Level I inspectors
What you need
- Level II certification in one or more NDT methods used at the site
- Three to four years of NDT work on aircraft
- Able to work from manufacturer documentation, airworthiness directives, service bulletins and structural repair manuals
- Knowledge of the rules for an FAR 145 repair station
- Associate's degree or about four years of related experience or training
- Physically able to handle loads of 75 lb
Pay and conditions
- Full-time, paid hourly with overtime
- FAA A&P licence preferred, not required
How to apply
Apply directly with AAR: the Apply for this job button opens this vacancy on the AAR careers site. NDT Inspect found it on the employer’s careers page and checked that it was open on 21 November 2026. It is listed here until 21 February 2027.
















