calibration of UT devices

  • General NDT Group

    calibration of UT devices

    Posted by arsal on 15/10/2021 at 1:17 am

    hello , i’m an instrumentation technician with not much experience on NDT,
    i need some help regarding the calibration of UT equipment ( USM 36, EPOCH 650, …. )
    i did bought the necessary equipment ( oscilloscope, signal generator, lead ….),
    new i have to perform the calibration, i will appreciate if anyone could help me by sharing the procedure or asiste me technically by video or phone call
    thank you by advance

    arsal replied 2 years, 6 months ago 1 Member · 0 Replies
  • 0 Replies

    Sorry, there were no replies found.

    Log in to reply.

    Start of Discussion
    0 of 0 replies June 2018
    Now

    Report

    Block Member?

    Please confirm you want to block this member.

    You will no longer be able to:

    • See blocked member's posts
    • Mention this member in posts
    • Invite this member to groups
    • Message this member
    • Add this member as a connection

    Please note: This action will also remove this member from your connections and send a report to the site admin. Please allow a few minutes for this process to complete.

    Report

    You have already reported this .