Custom ToFD inspection, for high thickness

  • Time of Flight Diffraction (ToFD)

    Custom ToFD inspection, for high thickness

    Posted by harry on 27/11/2021 at 7:20 pm

    Hey good day,

    I’m planning for ToFD inspection of more 250 mm carbon steel weld by customised ToFD wedges having angle less than 45 degree.

    any one have experience to share..

    Anthony Wohali replied 7 months, 1 week ago 2 Members · 1 Reply
  • 1 Reply
  • Time of Flight Diffraction (ToFD)

    Anthony Wohali

    Member
    28/11/2021 at 3:46 pm
    1 Point
    Up
    0
    Down
    ::

    You should follow the codes and use several pair of probes and multi-channel unit
    The thickness of the material to be divided in several regions and the time base (delay and range) to be calibrated accordingly

Reply

Reply to: harry
Cancel
Your information:

Reply

Start of Discussion
0 of 0 replies June 2018
Now

Report

Harassment or bullying behavior
Contains mature or sensitive content
Contains misleading or false information
Contains abusive or derogatory content
Contains spam, fake content or potential malware

Block Member?

Please confirm you want to block this member.

You will no longer be able to:

  • See blocked member's posts
  • Mention this member in posts
  • Invite this member to groups
  • Message this member
  • Add this member as a connection

Please note: This action will also remove this member from your connections and send a report to the site admin. Please allow a few minutes for this process to complete.

Report

You have already reported this