Sensitivity calibration in Phased Array Ultrasonics

  • Sensitivity calibration in Phased Array Ultrasonics

    Posted by Visitor on 01/09/2022 at 7:40 am
    Up
    0
    Down
    ::

    Hi,

    The manufacturer of the Phased Array equipment that I use indicates to calibrate the Sensitivity through the 1.5mm diameter side hole of the V1 block, but for acquisitions in large thicknesses (Example: butt joint 46 mm) the Sensitivity calibration in the 1.5mm diameter side hole of the V1 does not prove to be effective.

    We are using a block of the same P-number family of the base metal with an approximate thickness of 46mm, a side hole with a diameter of 3.2mm and a depth of 38mm and the acquisitions have been very satisfactory, finding all the defects of the mockup.

    Is this procedure correct, or is there something better I can do?

    Regards.

    Visitor replied 3 weeks, 4 days ago 1 Member · 0 Replies
  • 0 Replies

Sorry, there were no replies found.

Reply to: Visitor
Cancel
Your information:

Start of Discussion
0 of 0 replies June 2018
Now